Page 18
Page 19
DMC-1 Rear Panel Layout (Continued)
Ground Screw
This is commonly used for the ground
connection wire of a turntable, to prevent
any hum in your speakers. It is tied to
the chassis ground, and may be used as
needed.
Note: It is not necessary or desirable to connect
this to an electrical ground.
Stereo Outputs
FIXED MAIN is a line level output, and the
volume is not adjustable. This can be used
as a record output, or to feed another audio
system. ZONE 2 connects to the inputs of a
stereo amplier to run Zone 2. The volume
and source are adjustable, either from the
front panel, or from a remote IR sensor.
FM Antenna
The supplied FM antenna ts this “F-type”
screw-on connector. Other antennas can
be tted for improved reception.
AM Antenna
These connections are for the included AM
loop antenna.
Audio Outputs
These audio outputs connect to the analog
record inputs of your tape decks, such as
DAT, cassette or reel to reel. These outputs
allow you to record the selected audio
program. Note that these also allow analog
recording from digital audio sources.
Side-Axis Outputs
These outputs provide two optional front
side channels to complement the left,
center, right, surround and surround back
channels. They can be turned on or o using
the Speaker Size OSD menu (see page 56).
Audio Inputs
These audio inputs connect to the outputs
of your turntable, DAT or TAPE player. Any
standard audio component with a line-level
output can be connected to DAT or TAPE.
Only a turntable with a moving-magnet, or
high-output moving coil cartridge can be
connected to the PHONO input.
10
5
6
7
1
2
3
4
9
5 6 7
1
2
3 4 8
11