Filter
Top Products
Installation Manual 5
Installing the Transmitter Output Wiring – AnalogSensor WiringBefore You Begin
Chapter 2
Installing the Transmitter
2.1 Overview
This chapter describes how to install Micro Motion Model 1700 and 2700 transmitters. The following
general steps are required:
• Determine the location of the transmitter and other flowmeter components (see Section 2.3)
• Mount the transmitter (see Section 2.4)
• Mount the core processor, if required (see Section 2.5)
• Ground the flowmeter components (see Section 2.6)
• Supply power to the flowmeter (see Section 2.7)
• Rotate the display, if desired and the transmitter has a display (see Section 2.8)
2.2 Installation architecture
Your flowmeter installation will match one of the architectures shown in Figure 2-1. Mounting, sensor
wiring, and grounding requirements depend on this architecture. Your installation type should be
consistent with the installation type specified in your transmitter model number (see Section 1.4).