Filter
Top Products
Installation Manual 3
Before You Begin
Installing the Transmitter Output Wiring – AnalogSensor WiringBefore You Begin
1.5 Transmitter installation procedures
To install the transmitter, the following procedures are required:
• Install the transmitter – see Chapter 2
• Wire the transmitter to the sensor – see Chapter 3
• Wire the transmitter outputs:
- For Model 1700 or 2700 analog outputs transmitters, see Chapter 4.
- For Model 1700 or 2700 intrinsically safe analog outputs transmitters, see Chapter 5.
- For Model 2700 configurable I/O transmitters, see Chapter 6.
- For Model 2700 F
OUNDATION fieldbus and PROFIBUS-PA outputs transmitters, see
Chapter 7.
1.6 Flowmeter documentation
Table 1-1 lists documentation sources for other required information. Documents can be obtained in
PDF form from the Micro Motion web site (www.micromotion.com/documentation).
Table 1-1 Flowmeter documentation resources
Topic Document
Sensor installation Installation manual shipped with sensor
Core processor installation (if mounted
remotely from sensor and transmitter)
This document
Transmitter configuration, transmitter
startup and use, and transmitter
troubleshooting
Series 1000 and 2000 Transmitter Configuration and
Use Manual
or
Model 2700 Transmitter with F
OUNDATION Fieldbus
Installation and Operation Manual
or
Model 2700 Transmitter with PROFIBUS-PA
Installation and Operation Manual