Filter
Top Products
Installation Manual 25
Wiring the Transmitter to the Sensor
Installing the Transmitter Output Wiring – AnalogSensor WiringBefore You Begin
Figure 3-7 Wrapping the shield drain wires
e. Place the shielded heat shrink over the exposed shield drain wire(s). The tubing should
completely cover the drain wires. See Figure 3-8.
f. Without burning the cable, apply heat (250 °F or 120 °C) to shrink the tubing.
Figure 3-8 Applying the heat shrink
g. Position gland clamping insert so the interior end is flush with the heat shrink.
h. Fold the cloth shield or braid and drain wires over the clamping insert and approximately
1/8 inch (3 mm) past the O-ring. See Figure 3-9.
Figure 3-9 Folding the cloth shield
i. Install the gland body into the core processor housing conduit opening. See Figure 3-10.