Filter
Top Products
Installation Manual 13
Installing the Transmitter
Installing the Transmitter Output Wiring – AnalogSensor WiringBefore You Begin
To mount the transmitter/core processor assembly:
1. Identify the components shown in Figure 2-6. For dimensions, see Appendix A.
2. If desired, re-orient the transmitter on the bracket.
a. Loosen each of the four cap screws (4 mm).
b. Rotate the bracket so that the transmitter is oriented as desired.
c. Tighten the cap screws, torquing to 30 to 38 in-lbs (3 to 4 N-m).
3. Attach the mounting bracket to an instrument pole or wall. For pipe mount, two user-supplied
U-bolts are required. Contact Micro Motion to obtain a pipe-mount installation kit if required.
Figure 2-6 Transmitter/core processor assembly – Exploded view
2.5 Mounting the remote core processor
Note: This step is required only for remote core processor with remote transmitter installations (see
Figure 2-1). If you have an integral installation, 4-wire remote installation, or 9-wire remote
installation, go to Section 2.6.
If you chose the remote core processor with remote transmitter installation (see Figure 2-1), see
Figure 2-3 for a diagram of the mounting bracket supplied with the transmitter. Both pipe mounting
and wall mounting are shown.
End-cap
Mounting bracket
Core processor housing
Transmitter
Core processor
4 × Cap screws (4 mm)
Conduit opening
for 9-wire cable