Chapter 2 35
Configuration management
ts_config
Figure 19 ts_config node reset panel
Step 3. In the Node Reset panel, select the desired “Reset Level” and “Boot
Options,” then click Reset.”
Deconfigure a Node
Deconfiguring a node removes the selected node from the teststation
configuration. The teststation will no longer monitor the environmental
and hard-error status of this node. Console access to the node is also be
disabled.
Step 1. Select the desired node from the list of available nodes.
Step 2. Select “Actions,” then “Deconfigure Node,” then click “Yes.”
Add/Configure the Terminal Mux
To add or reconfigure the terminal mux, perform the following
procedure.
Step 1. In the ts_config display, select “Actions,” then “Configure Terminal
Mux.”
Step 2. Select “Add/Configure Terminal Mux.” This is indicated in Figure 20.
