Chapter 11 245
Utilities
load_eprom
Example output of load_eprom -n hw2a-0000 -p entry.pdc command
Reading file “entry.pdc”: 4253 (0x109d) bytes read.
Using default SPAC (P0L).
Erasing sector 0 (0xf0000000) OK
Writing sector 0 (0xf0000000) .. OK
Example output of load_eprom -n hw2a-0000 -p post.fw command
Reading file “post.fw”: 92820 (0x16a94) bytes read.
Using default SPAC (P0L).
Erasing sector 4 (0xf0020000) OK
Writing sector 4 (0xf0020000) ....................... OK
Example output of load_eprom -n hw2a-0000 -o obp.pdc command
Reading file “obp.pdc”: 499712 (0x7a000) bytes read.
Using default SPAC (P0L).
Erasing sector 7 (0xf0080000) OK
Writing sector 7 (0xf0080000) ................................ OK
Erasing sector 8 (0xf00a0000) OK
Writing sector 8 (0xf00a0000) ................................ OK
Erasing sector 9 (0xf00c0000) OK
Writing sector 9 (0xf00c0000) ................................ OK
Erasing sector 10 (0xf00e0000) OK
Writing sector 10 (0xf00e0000) .......................... OK
While load_eprom is writing a block of data, a “w” is printed. If the
write is successful, a dot is printed. The dots continue until the whole
sector is successfully written, at which time the “OK” is printed.
