Filter
Top Products
programme automatically from the EPGplus data. Both the starting and the ending time of
the programme will be taken over correct to the nearest minute. However, it frequently
happens that the selected programme starts a little earlier or a little later than scheduled. In
this case the start or the end of the programme may be missing from the recording. To
overcome this problem, you can enter a pre- or post-run time for the timer, in steps of one
minute at a time. The timer will then start earlier and end later than given in the EPGplus
data by the entered pre-run and post-run times.
> Press the red function key Timer to open a selection window.
> Use the arrow keys up/down to mark the line Timer settings.
> Confirm by pressing OK.
A menu will be displayed allowing you to enter the pre-and post-run times.
> Now use the arrow keys up/down to mark the line Timer pre-run time and
Timer post-run time.
> Use the numeric keys to enter the desired pre- or post-run time in minutes.
> Press the green function key Accept to save the setting and return to the previous
EPGplus table.
7.16.7.3 EPGplus programme overview
You can use the EPGplus programme overview to display a table with the whole day's
listings for an individual channel. Proceed as follows:
> Press the EPG key.
If you have selected the start category Overview, see Point 9.2.3, the “Now”
EPGplus table will appear.
> While the “Now” EPGplus table is displayed, press the green function key to switch
directly to the channel listings.
or
> press the blue function key EPG Menu.
> In the selection window, use the arrow keys up/down to mark the line
Programmes.
> Confirm by pressing OK.
The day’s overview of the selected channel will now be displayed.
> You can use the arrow keys to move the marker to the desired programme or time.
The individual days of the week are displayed along the lower edge of the screen. If
information is available for the following days, the appropriate fields will be marked.
> To display the programme content of a specific day, press the corresponding
numeric key.
Displaying the EPGplus overview for other channels
> Press the yellow function key Programmes.
A list of EPGplus programmes will be displayed.
> You can now proceed to mark the desired channel using the arrow keys.
> Press the OK key to display the EPG overview of the marked channel.
7.16.7.4 EPGplus overview by type of programme (genre)
39
7