Filter
Top Products
5 Initial installation
After you have read the safety notes and connected the unit as described in Chapter 4,
switch the unit on as described in Chapter 7.
When switching on the receiver for the first time, the starting window of the installation
assistant AutoInstall will be displayed. The installation assistant allows you to make the
most important settings of your digital receiver in the simplest way possible.
At each step of the installation there will be an explanation as to which settings can be made.
You can interrupt the initial installation by pressing the red function key in the starting
window of the installation assistant.
In the following steps of the installation, you can then confirm the settings made by pressing
the green function key; you will then be taken to the next step of the installation procedure.
If you press the red function key you will be taken to the previous step of the installation,
thus giving you an opportunity to correct errors at any time.
If the initial installation is not performed, or if it is aborted, the receiver will commence
operation with a standard pre-programmed procedure.
The initial installation process shown here serves merely as an example.
The exact process of the initial installation will depend on the settings you select. Please
therefore follow all instructions displayed on screen carefully
Operating language
> When starting the installation assistant, the first selection window to be displayed will
be that for the Operating language.
> Using the arrow keys, select the desired operating language.
> Confirm by pressing the green function key Accept.
Country setting
> Using the arrow keys, select the country in which the unit is being used. The
selection made here will result in the time zone being set, and will affect the sorting of
the programme list.
> Using the green function key confirm Accept in order to accept the selection of the
picture format.
Picture format
> Using the arrow keys right/left adjust the picture format of the connected TV set.
Depending on your selection the automatic alignment of the picture to the TV set will
take place.
> To accept the selection and to gain access to the selection of antenna signals confirm
with OK.
Antenna signals
Here you must select how many antenna signals are connected to the receiver.
> Using the right/left arrow keys select whether you have connected one or two
antenna signals.
15
5