Filter
Top Products
corresponding programme. If there is a picture available, it is indicated by .
> Use the arrow keys or the function keys to mark the desired programme.
> Press the EPG key to display information and/or the picture relating to the
programme.
> Lengthy information text can be moved or paged through with the help of the arrow
keys.
> Press the Back key to return to the previous table.
7.16.7.2 EPGplus Timer programming
You can use the EPGplus Electronic Programme Guide to programme timer events easily.
You can also use this function to programme the Timer for Multifeed programmes e.g. from
the Premiere Sport Portal. Timer can only be programmed for Multifeed programmes in the
EPGplus programme overview (see Point 7.16.7.3).
> Use the arrow keys or the function keys to mark the desired programme.
> Press the Record, key to programme a Hard drive Timer for the marked
programme (see Point 8.1.2).
or
> Press the Option key once to programme a Channel change timer for the
marked programme (see Point 8.1.2).
> Press the Option key once again to change the Timer type to a VCR timer.
or
> Press the red function key Timer to open a selection window.
> Use the up/down arrow keys to mark the desired Timer type (see Point 8.1.2).
> Confirm by pressing OK.
For control purposes the menu Managetimer will display the data relative to the
selected programme. If necessary, you can effect any changes here (see 8.1.2).
> Press the Back key to return to the previous table.
The appropriate line is now marked. Depending on the Timer type, your receiver will
now be switched on at the starting time of the selected programme. If the unit was
switched on by the PVR Timer, this will be indicated by “ PVR Timer” being shown in
the display. In standby mode, the active Timer will be indicated by a clock symbol
next to the time display.
Deleting the EPGplus timer event
> If you would like to cancel an EPGplus-programmed timer event, proceed as
described above to mark the corresponding programme.
> Press the red function key Timer to open a selection window.
> Use the up/down arrow keys to select the line Delete timer.
> Confirm by pressing OK.
or
> Delete a timer as described under Point 8.1.2.4.
Timer settings (pre- and post-run time)
With EPGplus Timer programming, the receiver obtains the data relating to the selected
38
7