Mono mode indicator.
Correction preset selection
To select one of the nine correction presets or to bypass them use the “
LEFT” or
“RIGHT” navigation buttons to position the cursor over CR (1). Once the cursor
is positioned over CR (1) press the “ENTER” button. The system will then display
a pull down list containing all presets. Use the “UP” and “DOWN” navigation but-
tons to point to the desired correction preset and then press the “ENTER” button.
This action will engage the selected preset and will display the new selection in
the CR box (1). Once the cursor is positioned over CR (1) you can also select a
correction preset by pressing one of the ten buttons located in the block labeled
“CORRECTION” on the remote control. The 2.2 XP will display a <
*
> next to the
selected presed indicating that the preset was loaded.
EQ preset selection
To select one of sixteen parametric EQ presets or to bypass them use the
“LEFT” or “RIGHT” navigation buttons to position the cursor over EQ (2). Once
the cursor is positioned over EQ (2) press the “ENTER” button. The system will
then display a pull down list containing all presets. Use the “UP” and “DOWN”
navigation buttons to point to the desired EQ preset and then press the “EN-
TER” button. This action will engage the selected preset and will display the new
selection in the EQ box (2). Once the cursor is positioned over EQ (2) you can
also select a correction preset by pressing one of the ten buttons located in the
block labeled “CORRECTION” on the remote control. The 2.2 XP will display a
