Filter
Top Products
7Tact Audio
Unpacking the RCS 2.0S
Carefully remove the RCS 2.0S and accessory kit from the carton and visually check
for shipping damage. Contact both the shipper and Tact Audio immediately if the unit
shows any sign of damage from rough handling. All Tact Audio equipment is carefully
inspected before leaving our factory.
KEEP THE SHIPPING CARTON AND PACKING MATERIALS for future use or in the
unlikely event that the unit needs servicing. If this unit is shipped without the original
packing, damage could occur and void the warranty.
You should find the following items in the accessory kit:
- one AC mains cord
- RJ11 data cable
- RJ11-to-RS232 adapter
- 15’ RS232 cable
- CD-rom with RCS software
- Measurement microphone
- remote control
- 2 AAA batteries
- this manual
The RCS-2.0 S is designed with an automatic switching power supply. It will operate
on 65-265 volts at 50-60hz. No external settings are required.
The RCS-2.0 S has three operating modes:
- OFF AC mains power is cut off, either via the rear
panel mains switch, or by unplugging the unit from the
wall outlet.
- STANDBY The unit is powered but all outputs are muted and the
display is off. The unit uses very little current and
is “idling” or “sleeping”. Use the remote or front panel
“STANDBY” button to toggle between ON and STANDBY.
- ON Everything is powered and ready to go.
Accessories
Operating voltage