Filter
Top Products
33Tact Audio
1 - Turn on your computer.
2 - Open the Windows control panel and select the “Add/Remove
Programs” option.
3 - Highlight the “TacT-2.0S” option and click on “Change/Remove”.
4 - Select “Yes” and the old Tact 2.0S software will be removed.
NOTE:Your target curves and measurements stored under unique names
will NOT be removed.
1 - Connect the PC to the RCS 2.0S using the RS232 cable. Please refer to
the RCS 2.0S RS232 section of the user’s manual or the RS232 Connection
document for help.
CAUTION: There should only be one RCS 2.0S connected to the RS232 cable
during system reprogramming. Please disconnect any other RCS 2.0S units
that may be daisy chained to the RCS 2.0S that is being programmed.
Update the RCS 2.0S Firmware
Step I:
Removing your old
RCS 2.0S Software
Step III:
Reprogramming the
RCS 2.0S Firmware
4 - Turn the RCS 2.0S OFF from the rear panel mains switch.
3 - Use the “Communication” option in the Tact 2.0S room correction software to
make sure that the RCS 2.0S and your computer are communicating. Please refer
to the RCS 2.0S RS232 section of the user’s manual or the RS232 Connection
document for help.
Your RCS 2.0S has been pre-programmed with the latest firmware when shipped
from our factory and does not need to be updated with the program CD that came
with your unit. TacT Audio may occasionally release updated versions of the RCS
software that will be available on our website “www.tactaudio.com”. This new
software may contain updates or enhancements for your RCS 2.0S. When
instructed by a technician or messaged from our website please follow the
instruction below to update your RCS 2.0S firmware.
2 - Start the RCS 2.0S correction software on your computer
Step II:
Install your new
RCS 2.0S Software
- Double-click on the “Tact 2.0S vx.x.exe” file that you have downloaded or is
found on the root of your CD and follow the installation instructions.
You now need to install the new TacT 2.0S RCS software on your computer.
Program the new firmware for the RCS 2.0S.
First un-install the current version of the RCS 2.0S correction software on your
computer.