Filter
Top Products
17Tact Audio
DELAY menu
LEFT RIGHT CR:2
0.00 0.00 msec
The main menu of the RCS 2.0S has three pages of general menu selections.
<- AMP REM ADDR
POL PAREQ TONE ->
MAIN menu
NOTE: The RCS 2.0S provides a unique set of two delay times (Left and
Right) for each room correction preset including bypass.
NOTE: System balancing is automatically implemented by the room correc-
tion software. You would change these parameters only if you needed addi-
tional adjustment.
<- OFS INFO
DELAY LEVEL ADC
DISPL TEST OUT ->
1
Front Panel Display
Saving Menu
Settings
Custom settings that are made to any of the menu selections can be saved by
placing the RCS 2.0S into standby mode. If you make changes to any of the menu
items and turn the unit off before placing it into standby mode all settings will be lost.
To place the RCS 2.0S into standby mode press STANDBY button found on the front
panel of the unit or the red “STANDBY” button on the remote control.
1 - Individual channel delay time settings.
2 - Current correction preset. (selectable from the main screen)
Main Menu :
Delay Menu :
To enter the Menu selection pages press the “MENU” button. Use the “LEFT” and
“RIGHT” navigational buttons to highlight an option with the selection cursor and to
proceed to a new page. To enter a highlighted option press the “ENTER” button.
Once you are in a menu option use the “MENU” button to go back one step (from
sub-menus) with each press or to return to the main operating screen.
2
The Delay menu controls the systems time alignment. You can adjust the systems
time alignment by changing the delay time for the left and right outputs indepen-
dently.
Use the “LEFT” and “RIGHT” navigational buttons to highlight an option and use the
“UP” and “Down” buttons to change its value .