Filter
Top Products
CAUTION
CAUTION
30 Tact Audio
STEP II
Do you have one or more M/S 2150 digital amplifier connected to your
RCS 2.0S?
- If you do not use Tact digital amplifiers select “No”. Then select the “Next” button
and go to Step III.
STEP I
- Loudspeaker lower cutoff frequency (this is the lowest frequency that your
loudspeakers can reproduce)
Getting Started
Start the Quick Setup by selecting the yellow “Quick Setup” button located on the
Tact 2.0 S Room Correction software’s main window.
The Tact 2.0S Quick Setup wizard is broken into three steps. As you complete
each step select the “NEXT” button proceed to the next step.
Set the Loudspeaker Lower Cutoff frequency. Your main loudspeaker
frequency response will determine the setting needed for this parameter. Please
refer to your main loudspeaker manual for this information.
Quick Setup