Filter
Top Products
34
Tuner
Presetting radio stations
You can preset 20 stations for FM and 10
stations for AM.
1 Press TUNER/BAND repeatedly to
select “FM” or “AM”.
Pressing TUNER/BAND turns on the
system.
2 Press TUNING MODE repeatedly until
“AUTO” appears.
3 Press TUNING + or – (or + or – on the
remote).
The frequency indication changes and the
scanning stops when the system tunes in a
station. “TUNED” and “STEREO” (for a
stereo programme) appear.
4 Press MENU/NO on the remote.
5 Press TUNING + or – (or + or – on the
remote) until “Memory?” appears, then
press ENTER/YES on the remote.
The preset number starts flashing. Perform
steps 6 and 7 while the preset number is
flashing.
6 Press TUNING + or – (or + or – on the
remote) repeatedly to select the desired
preset number.
7 Press ENTER/YES on the remote.
“Complete!” appears, and then the station is
stored.
8 Repeat steps 1 to 7 to store other
stations.
To stop scanning
Press TUNING MODE.
To tune in a station with a weak
signal
Press TUNING MODE repeatedly until
“MANUAL” appears in step 2, then press
TUNING + or – (or + or – on the remote)
repeatedly to tune in the station manually.
To change the preset number
Start over from step 1.
To change the AM tuning interval
(except for the European model)
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,
then turn off the system. While holding down
FUNCTION, turn the system back on. When
you change the interval, all the AM preset
stations are erased. To reset the interval, repeat
the same procedure.
Tip
The preset stations are retained for about a day even if
you disconnect the mains lead or if a power failure
occurs.