Filter
Top Products
25
MD – Editing
Labelling an MD
— Name Function
You can create titles for your recorded MDs
and tracks as follows.
During recording
If “TEXT” lights up or flashes during
recording, you can record the CD TEXT
information onto the MD as follows:
• Automatically during recording
If you record on an unrecorded or
completely erased (see “Erasing all tracks”
on page 27) MD when “TEXT” is lit, the CD
TEXT information is automatically recorded.
• Manually during recording
When “TEXT” flashes, press NAME EDIT
on the remote, and then press ENTER/YES
on the remote to record the title of the
current track.
Note
Depending on the disc, the CD TEXT information
may not be recorded automatically.
After recording
Use Name Function on this page. You can
input a total of approximately 1700 characters
for the disc title and track titles on a single MD.
1 Press FUNCTION repeatedly to switch
the function to MD.
To label a track, press . or > for the
MD until the desired track number appears.
2 Press NAME EDIT on the remote.
The cursor starts flashing.
3 Press SELECT on the remote to select
the desired type of character.
Each time you press the button, the display
changes cyclically as follows:
Selected AB* (Upper cases) t Selected ab
(Lower cases) t Selected 12 (Numbers)
* Press number 1 repeatedly to display the
following symbols.
‘ – / , . ( ) : ! ?
In addition, when the symbols above appear in
the display, press . or > for the MD
repeatedly to display the following symbols.
& + < > _ = ” ; # $ % @
`
4 Enter a character using the remote.
If you have selected uppercase or
lowercase letters
1 Press the corresponding letter button
repeatedly until the character to be
entered flashes.
Or, press the button once and press .
or > repeatedly.
2 Press CURSORt.
The flashing character is entered and the
cursor shifts to the right.
If you have selected numbers
Press the corresponding number button.
The number is entered and the cursor shifts
to the right.
To enter a blank space
1 Press SELECT repeatedly until “Selected
AB” or “Selected ab” appears in the
display.
2 Press 10/0.
A blank space is entered and the cursor
shifts to the right.
continued