Filter
Top Products
24
Before you start editing
Before editing
You can edit an MD only when:
• The MD is recordable.
• The MD play mode is normal play.
Check the following, before editing.
1 Check the tab of the MD to be edited.
If the MD is protected when you press
MENU/NO on the remote, “C11” and
“Protected” appear alternately and the MD
cannot be edited.
Slide the tab to close the slot.
2 Press PLAY MODE repeatedly until
both “PROGRAM” and “SHUFFLE”
disappear.
You can edit the MD only in normal play
mode. You cannot edit the MD in Shuffle or
Programme Play mode.
To cancel the last edit
Use Undo Function to cancel the last edit and
restore the contents of the MD to the condition
before the edit (see page 31).
To quit while editing
Press MENU/NO on the remote.
After editing
Press ZMD to remove the MD or press ?/
1 (power) to turn off the system.
“TOC” lights up or starts flashing. The TOC is
updated and editing is completed.
Before pulling out the mains lead
MD editing is completed when the MD Table
of Contents (TOC) is updated. The TOC is
updated when you eject the MD or press ?/1
to turn off the system. Do not pull out the
mains lead before updating the TOC (while
“TOC” is lit) or while updating the TOC (while
“TOC” is flashing) to ensure a complete
editing.
MD – Editing