Filter
Top Products
16
Note on MD track numbers
On an MD, the track numbers (track sequence), track
start and end point information, etc., are recorded in
the TOC*
2
area independent of the sound information.
You can edit recorded tracks quickly by modifying
the TOC information.
*
2
TOC: Table Of Contents
After recording
Press ZMD to remove the MD or press
?/1 (power) to turn off the system.
“TOC” lights up or starts flashing. The TOC is
updated and recording is completed.
Before pulling out the mains lead
MD recording is completed when the MD
Table of Contents (TOC) is updated. The TOC
is updated when you eject the MD or press ?/1
to turn off the system. Do not pull out the
mains lead before updating the TOC (while
“TOC” is lit) or while updating the TOC (while
“TOC” is flashing) to ensure a complete
recording.
Protecting a recorded MD
To protect a recorded MD, slide the tab on the
side of the MD to open the slot. In this position,
the MD cannot be recorded. To record on the
MD, slide the tab to close the slot.
Before you start recording
MDs (MiniDisc) let you digitally record and
play music with high quality sound. Another
feature of MDs is track marking. The track
marking feature lets you quickly locate a
specific point or easily edit the recorded tracks.
However, depending on the source you record,
the recording method and the way the track
numbers are recorded differ.
When the source you record from is:
• This system’s CD player
– The MD deck performs digital recording.*
1
– Track numbers are automatically marked as
on the original CD.
• Other digital components
connected to the DIGITAL
OPTICAL IN jack
– The MD deck performs digital recording.*
1
– Track numbers are marked differently
depending on the source you record.
• This system’s tuner and other
analogue components connected
to the TAPE IN jacks (e.g., the
optional tape deck TC-TX21)
– The MD deck performs analogue recording.
– A track number is marked at the beginning
of a recording, but when you turn on the
Level Synchro Recording function (see
“Marking track numbers” on page 21), track
numbers are automatically marked in sync
with the level of the input signal.
*
1
For details on the limitations of digital recording,
see “System limitations of MDs” on page 43.
When you use a partially recorded
MD
Recording starts after the recorded tracks.
MD – Recording
Tab
Slide the tab