Filter
Top Products
62
GB
CMT-CP505MD 4-241-515-11(2) GB
Notes on CDs
• Before playing, clean the CD with a cleaning cloth.
Wipe the CD from the center out.
• Do not use solvents such as benzene, thinner,
commercially available cleaners or anti-static spray
intended for vinyl LPs.
• Do not expose the CD to direct sunlight or heat
sources such as hot air ducts, nor leave it in a car
parked in direct sunlight.
• Do not use a CD encircled with a protection ring.
This may cause a malfunction to the system.
• When using a CD that have glue or similar tacky
substance on the label side of the CD or that used a
special ink when the label was printed, there is a
chance that the CD or label may become attached to
parts inside this unit. When this occurs, it may not
be possible to remove the CD, and may also cause
this unit to malfunction. Be sure to check that the
label side of the CD is not sticky before using.
The following types of disc should not be used:
— Rental or used CD with attached seals where
the glue extends beyond the seal. The perimeter
of the seal on the CD is tacky.
— CDs that have labels printed using a special ink
that feels tacky when touched.
• CDs with non-standard shapes (e.g., heart, square,
star) cannot be played on this unit. Attempting to do
so may damage the unit. Do not use such CDs.
Note on CD-R/CD-RW playback
Discs recorded on CD-R/CD-RW drives may not be
played back because of scratches, dirt, recording
condition or the drive’s characteristics. Besides, the
discs, which are not yet finalized at the end of
recording, cannot be played back.
Cleaning the cabinet
Clean the cabinet, panel and controls with a soft cloth
slightly moistened with mild detergent solution. Do
not use any type of abrasive pad, scouring powder or
solvent such as thinner, benzene or alcohol.
To save a tape permanently
To prevent a tape from being accidentally recorded
over, break off the cassette tab from side A or B as
illustrated.
If you later want to reuse the tape for recording, cover
the broken tab with adhesive tape.
Before placing a cassette in the tape
deck
Take up any slack in the tape. Otherwise, the tape
may get entangled in the parts of the tape deck and
become damaged.
When using a tape longer than
90 minutes
The tape is very elastic. Do not change the tape
operations such as play, stop, and fast-winding
frequently. The tape may get entangled in the tape
deck.
Cleaning the tape heads
Clean the tape heads after every 10 hours of use.
Be sure to clean the tape heads before you start an
important recording or after playing an old tape.
Use a separately sold dry-type or wet-type cleaning
cassette. For details, refer to the instructions of the
cleaning cassette.
Demagnetising the tape heads
Demagnetise the tape heads and the metal parts that
have contact with the tape after every 20 to 30 hours
of use with a separately sold demagnetising cassette.
For details, refer to the instructions of the
demagnetising cassette.
Break off the
cassette tab
Precautions (continued)