Filter
Top Products
48
GB
CMT-CP505MD 4-241-515-11(1) GB
Waking up to music
— Daily Timer
You can wake up to music at a preset time.
Make sure you have set the clock (see “Setting
the clock” on page 8).
1 Prepare the sound source you want to
play.
• CD: Load a CD. To start from a
specific track, make a program (see
“Programming CD tracks” on page 10).
• MD: Load an MD. To start from a
specific track, make a program (see
“Programming MD tracks” on page 15).
• Tape: Load a tape.
• Radio: Tune in the preset radio station
(see “Listening to the radio” on page
42).
2 Press VOLUME + or – on the remote to
adjust the volume.
3 Press CLOCK/TIMER SET on the
remote to display “DAILY SET”.
4 Press ENTER/YES on the remote.
“ON” appears and the hour indication
flashes.
5 Set the time to start playing.
Press . or > on the remote repeatedly
to set the hour, then press ENTER/YES on
the remote.
The minute indication flashes.
Press . or > on the remote repeatedly
to set the minute, then press ENTER/YES
on the remote.
“OFF” appears and the hour indication
flashes again.
6 Set the time to stop playing following
the same procedure as step 5.
Falling asleep to music
— Sleep Timer
You can set the system to turn off after a
certain time, so that you can fall asleep to
music.
Press SLEEP on the remote.
Each time you press the button, the minute
display (the turn-off time) changes cyclically as
follows:
SLEEP OFF t AUTO* t 90min t 80min
t
…
t 10min
* The system automatically turns off in 100 minutes
or after the current CD, MD or tape finishes
playing.
To
Check the
remaining time**
Change the time
to turn off
Cancel the Sleep
Timer Function
** You cannot check the remaining time if you select
“AUTO”.
Note
Do not set to “AUTO” during Synchro Recording on
an MD or a tape.
Press
SLEEP on the remote once.
SLEEP on the remote to select
the time you want.
SLEEP on the remote repeatedly
until “SLEEP OFF” appears.
Timer