Filter
Top Products
17
GB
MD – Recording
CMT-CP505MD 4-241-515-11(1) GB
When you use a partially recorded
MD
You cannot record while overwriting the
recorded tracks.
Recording starts after the recorded tracks.
If you want to erase the recorded tracks, erase
the tracks using Erase function (page 33).
Note on MD track numbers
On an MD, the track numbers (track sequence),
track start and end point information, etc., are
recorded in the TOC*
3
area independent of the
sound information. You can edit recorded
tracks quickly by modifying the TOC
information.
About recording errors
• With the following kinds of CDs, you may
experience a reading failure or noise when
recorded on an MD:
— CDs with adhesive labels attached to them
— Irregularly shaped CDs (for example, heart- or
star- shaped)
— CDs with printed text concentrated on one side
only
— Scratched CDs
— Dirty CDs
— Warped CDs
• If the following occurs during CD playback or
recording, a reading error may occur or noise may
be produced in the recorded results:
— The disc tray or other part of the system is
bumped.
— The system is placed on an uneven or soft
surface.
— The system is located near a speaker, door, or
other source of vibration.
• If the above reading errors occur, an extra soundless
track may be created. You can erase these extra
tracks using Erase Function (page 33).
*
1
For details on the limitations of digital recording,
see “System limitations of MDs” on page 63.
*
2
Even if you connect a digital component, the MD
deck performs analog recording.
*
3
TOC: Table Of Contents
Tab
Slide the tab
After recording
Press MD Z to remove the MD or press
?/1 (power) to turn off the system.
“TOC” or “STANDBY” starts flashing. The
TOC is updated and recording is completed.
Before pulling out the power cord
MD recording is completed when the MD
Table of Contents (TOC) is updated. The TOC
is updated when you eject the MD or press ?/1
to turn off the system. Do not pull out the
mains lead before updating the TOC or while
updating the TOC (while “TOC” lights up or
flashes) to ensure a complete recording.
Protecting a recorded MD
To protect a recorded MD, slide the tab on the
side of the MD to open the slot. In this position,
the MD cannot be recorded. To record on the
MD, slide the tab to close the slot.