Filter
Top Products
50
GB
CMT-CP505MD 4-241-515-11(1) GB
Other operations
To
Check the settings/
activate the timer
Change the setting
Cancel the timer
Tip
When you record from the radio, the station name (or
the frequency when the station is not labelled. See
page 43) is recorded on an MD together with the start
time and the stop time.
Notes
• You cannot activate the Daily Timer and recording
timer at the same time.
• If you use the recording timer and the Sleep Timer
at the same time, the Sleep Timer has priority.
• Do not operate the system from the time the system
turns on until the recording starts (about 30 seconds
before the preset time).
• If the system is on about 30 seconds before the
preset time, the timer-recording will not be
activated.
• The volume is reduced to minimum during
recording.
• When you record on an MD, if timer recording is
set with the Group Function on but no group is
specified, the material is recorded into a new group.
Do this
1Press CLOCK/TIMER
SELECT on the remote, then
press . or > on the
remote until “MD REC?” or
“TAPE REC?” appears.
2Press ENTER/YES on the
remote.
Start over from step 1.
1Press CLOCK/TIMER
SELECT on the remote, then
press . or > on the
remote until “TIMER OFF?”
appears.
2Press ENTER/YES on the
remote.
Display
Turning off the display
— Power Saving Mode
Even if the system is off, the system consumes
power to display the clock and to stay
responsive to commands from the remote.
Power saving mode reduces the amount of
power consumed during standby.
In this mode, the clock is not displayed.
Press DISPLAY on the remote repeatedly
while the system is off until the clock
display disappears.
To cancel Power Saving Mode
Press DISPLAY while the system is off. Each
time you press the button, the display switches
as follows:
Clock display* y No display (Power Saving
Mode)
* When the clock is not set, “--:--” appears.
Tip
The timer continues to operate in Power Saving
Mode.
Timer recording radio programs
(continued)