Filter
Top Products
<P=002>
(Continued)
U TOC ∗ ERR
(∗:Number or
Symbol)
● TOC information recorded on the MD does not
match the MD specifications or it cannot be
read.
● Replace it with another disc.
● Erase all of the track, and try recording.
U TOC W ERR
● The TOC information could not be created
properly due to a mechanical shock or to
scratches on the disc.
● Turn off the power, and try to write the TOC
again.
(Remove any source of shock or vibration
whilst writing.)
? DISC
● The data contains an error.
● Replace it with another disc.
00:00
● Music is not being recorded. ● Replace the disc with another recordable disc.
■ Moisture condensation
In the following cases, condensation may form inside
the unit.
● Shortly after turning on a heater.
● When the unit is placed in a room where there is
excessive steam or moisture.
● When the unit is moved from a cool place to a warm
place.
When the unit has condensation inside, the disc signals
cannot be read, and the product may not function
properly.
● If this happens, remove the disc. The condensation
should evaporate in approximately 1 hour. The unit
will then function properly.
■ If a problem occurs
If this product is subjected to strong external interference (mech-
anical shock, excessive static electricity, abnormal supply voltage
due to lightning, etc.) or if it is operated incorrectly, it may mal-
function or the display may not function correctly. If such a prob-
lem occurs, do the following:
● To erase all of the stored memory contents (clock and timer
settings, and tuner, MD and CD presets).
● If the display is not correct.
● If the operation is not correct.
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Press the ON/STAND-BY button whilst holding down the
button and the DELETE/CLEAR button.
Caution:
● The operation explained above will erase all data stored in
memory including clock and timer settings, and tuner, MD and
CD presets.
TRANSPORTING THE UNIT
Before you move this product to a new location, proceed
as follows:
1 Press the ON/STAND-BY button to turn the power on.
2 Remove all CDs, MDs and tapes inserted in the unit.
● Three CDs and three MDs can be inserted in the unit. There-
fore, make sure that all of them are removed.
3 Press the ON/STAND-BY button to enter the stand-by mode.
4 After "GOOD BYE" has gone out, unplug the AC power lead
from the AC socket.
MAINTENANCE
■ Internal care
● Dirty heads, capstan or pinch roller can cause poor sound
and tape jams. Clean these parts with a cotton swab moist-
ened with commercial head/pinch roller cleaner or isopropyl
alcohol.
● After long use, the deck’s heads and capstans may become
magnetised, causing poor sound. Demagnetise these parts
once every 30 hours of playing/recording time by using a com-
mercial tape head demagnetiser. Read the demagnetiser’s in-
structions carefully before use.
■ External care
● Periodically wipe the cabinet with a soft cloth and a diluted
soap solution, then wipe with a dry cloth.
● Do not use chemically treated cleaning cloths or other chemi-
cals.
1,3
2
2
MD-C2H(SUK) TINSE0238AWZZ
53