Filter
Top Products
<P=002>
RADIO OPERATION
■ Tuning
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TUNER (BAND) button.
3 Press the TUNER (BAND) button to select the desired fre-
quency band. (FM ST, FM or AM)
4 Press the TUNING ( or ) button to tune into the desired
station.
Manual tuning:
Press the TUNING ( or ) button as many times as required
to adjust the frequency shown on the display to the frequency of
the desired station.
Auto tuning:
When the TUNING ( or ) button is pressed for more than
0.5 seconds, scanning will start automatically and the tuner will
stop at the first receivable broadcast station.
Notes:
● When radio interference occurs during auto scan tuning, auto
scan tuning may stop automatically at that point.
● If a weak station signal is found during auto scan tuning, the
station will be skipped.
● To stop the auto tuning, press the TUNING ( or ) button
again.
● When an RDS (Radio Data System) station is tuned in, the
frequency will be displayed first, and then the RDS indicator
will light, Finally, the station name will appear.
5 To receive an FM stereo transmission, press the TUNER
(BAND) button so that the "ST" indicator on the display lights
up.
● " " will appear when an FM broadcast is in stereo.
6 If the FM reception is weak, press the TUNER (BAND) button
so that the "ST" indicator goes out.
● The reception changes to monaural, the sound becomes
clearer.
After use:
Press the ON/STAND-BY button to enter the stand-by mode.
Notes:
● The last station tuned in will be recalled, even after changing
the tuning band or the function, or after switching the unit to
the stand-by mode.
● If the unit’s AM/FM tuner interferes with the reception of a
nearby TV or radio, move the unit as far away from these
items as possible.
2,3,5,6
4
1
(Main unit operation)
MD-C2H(SUK) TINSE0238AWZZ
15