Filter
Top Products
2
HK <P=001>
(Continued)
When an error message is displayed, proceed as follows:
Error messages
Meaning
Remedy
BLANK MD
● Nothing is recorded. ● Replace it with another disc.
Can’t EDIT
● A track cannot be edited.
● Change the stop position of the track and then
try editing it.
Can’t REC
● Recording cannot be performed correctly due
to vibration or shock in the unit.
● The tape is protected against accidental
erasure.
● Re-record or replace the MiniDisc.
● Cover the accidental erase prevention hole.
CD NO DISC
● A CD has not been loaded.
● The disc data cannot be read.
● Load a CD.
● Reload the CD.
DEFECT
● Since this disc has scratches on it, the recor-
ding operation was skipped.
● Replace it with another recordable disc.
DISC FULL
● The MiniDisc is out of recording space. ● Replace it with another recordable disc.
EDIT OVER
● There is no space to make CD editing on the
disc.
● Replace it with a disc that has enough time
to record.
FOCUS ERR
● A disc has not been loaded.
● The disc data cannot be read.
● Reload the MiniDisc.
MD ∗∗ ERR
(∗:Number or
symbol)
● The disc is damaged.
● A TOC is not written on the MD or there is
something wrong with data.
● Reload the disc or replace it.
MD ERR
● Trouble is found. ● Contact the shop where you purchased the
unit.
MD NO DISC
● A MiniDisc has not been loaded.
● The disc data cannot be read.
● Load a MiniDisc.
● Reload the MiniDisc.
MECH ∗ ERR
(∗:Number or
symbol)
● There is a mechanical problem and the disc
is not working properly.
● Set this unit to the stand-by mode and press
the MD EJECT button.
NAME FULL
● The number of characters for the disc name
or track name exceeds 40.
● Shorten the disc or track name.
NOT AUDIO
● The data recorded on this disc is not audio
data.
● Select another track.
● Replace the disc.
PLAY MD
● You tried to record on a playback-only. ● Replace it with another recordable disc.
PROTECTED
● The disc is write protected. ● Move the write protection tab back to its orig-
inal position.
TEMP OVER
● The temperature is too high. ● Set this unit to the stand-by mode and wait
for a while.
TOC ∗∗ ERR
(∗:Number or
symbol)
● The disc is damaged.
● TOC information cannot be read.
● MD not specified.
● Replace it with another disc.
TOC FULL∗
(∗:Number or
symbol)
● There is no space left for recording character
information (track names, disc names, etc.).
● Replace it with another recordable disc.
TOC W ERROR
● Recording is impossible.
● Contact the shop where you purchased the
unit.
TRAY ERROR
● The CD tray operates incorrectly. ● Unplug the AC power lead, plug it back, and
then turn the power on.
MD-C2H(SUK) TINSE0238AWZZ
52