Filter
Top Products
<P=002>
(Continued)
In the following cases, the EON stand-by mode will be
cancelled.
● Press the ON/STAND-BY button to enter the stand-by
mode.
● When the unit is switched to another band in the EON
stand-by mode
● When you change the FM station whilst in the EON
stand-by mode
● When a preset call is made
Notes:
● During the same programme as the specified PTY (or TA) is
being broadcast on the station you are receiving, the unit will
not switch to other network station.
● If there are more than two other network stations you want to
listen to, compare the strength of each station’s signal and
tune in the station with the strongest signal. (EON-AF)
However, if the frequency of other network station has been
stored in the preset channel memory, the unit will switch to
that preset channel.
● If you want to cancel the reception of an ON (other network)
station which was tuned in by the EON system and return to
the original station you were receiving, press the EON button.
● After the unit returns to the original station, the stand-by mode
will still be active. (The "TI" or "PTY" will remain lit.)
● The unit will not switch from the ON station to another network
station. The unit returns to the original station.
● When the unit switches automatically to "other network" station,
if there is any problem with this station or the station cannot
be received properly "WEAK SIG" will appear and the unit will
return to the original station.
● Even if the unit switches from the station you are listening to
directly to some "other network" station, if the signals from the
other network stations are very weak, the unit will search for
the station with the strongest signal and switch to it.
However, if the signals from all the other network stations are
very weak, or if the tuning conditions are very bad (due to
electrical noise), the unit will stop searching, "WEAK SIG" will
be displayed, and the unit will return to the original station you
were receiving.
MD-C2H(SUK) TINSE0238AWZZ
26