Filter
Top Products
<P=003>
(Continued)
ENTER
MEMORY
TUNER
(BAND)
■ Preset tuning
You can store up to 40 stations in memory (40 stations consisting
of any combination of AM and FM stations you like) and recall
them.
To enter stations into memory:
1 Perform steps 1 - 6 in the "Tuning" section.
2 Press the MEMORY button.
3 Within 30 seconds, turn the jog dial to make the preset chan-
nel number flash in the display.
● Store the stations in memory, in order, starting with preset
channel 1.
4 Within 30 seconds, press the ENTER button to store that sta-
tion in the selected station preset number memory.
● If the "MEMORY" and preset number indicators go out before
the station is memorised, repeat the operation from step 2.
5 Repeat steps 1 - 4 to set other preset stations, or to change
a preset station.
● When a new station is stored in the selected station preset
number memory, the contents previously memorised will be
erased.
● To store an RDS station in memory, perform steps 2 - 4 whilst
the RDS station name is being displayed.
To recall a memorised station:
Turn the jog dial on the main unit or press the PRESET ( or
) button on the remote control for less than 0.5 seconds to
select the desired station.
● The stations (preset channel number, frequency and fre-
quency band) which have been stored in memory will appear
in the display in numerical order, irrespective of the frequency
bands.
Note:
When searching for a memorised station, do not press the
PRESET button for more than 0.5 seconds.
When the PRESET button is pressed for more than 0.5 seconds,
the unit will enter the preset memory scan mode.
Backup function:
The backup function protects all station presets for a few hours
should there be a power failure or the AC power lead is removed
from the AC socket.
■ Preset memory scan
The stations saved in the preset memory can be scanned auto-
matically.
1 To scan the preset stations, press the PRESET ( or )
button for more than 0.5 seconds.
● The station preset number will flash and the programmed sta-
tions will be tuned in sequentially, for 5 seconds each.
2 Press the PRESET ( or ) button again to stop the memory
scan at the desired station.
Note:
When the preset memory does not have any stations stored in
it, the preset memory scan will not function.
PRESET
( )
To erase all memorised stations:
When the unit is in the stand-by mode, hold and press the MEM-
ORY and TUNING buttons, and then press the ON/STAND-BY
button.
● "TUNER CL." will appear.
● After performing this operation, all of the preset memory in-
formation will be erased.
PRESET
( )
TUNER
(BAND)
Jog dial
(Remote control operation)
MD-C2H(SUK) TINSE0238AWZZ
16