Filter
Top Products
HK <P=001>
(Continued)
■ ASPM (Auto Station Program Memory)
It is recommended that you store stations in memory using
ASPM.
(This memory can be used for PTY searches, station select and
EON switching.)
When the ASPM button is pressed, whilst tuned to the FM band,
the RDS (Radio Data System) function will automatically search
for new RDS stations. Up to 40 stations can be stored in memory.
(If you have already stored some stations in memory, the number
of new stations you can store will be less.)
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TUNER (BAND) button.
3 Press the TUNER (BAND) button to select the FM ST or FM
band.
4 Press and hold down the ASPM button for at least 3 seconds.
①After "ASPM" has flashed for about 4 seconds, scanning will
start. (87.50 - 108.00 MHz)
②When an RDS station is found, the RDS will appear for a
short time and the station will be stored in memory.
③After scanning, the number of stations that have been auto-
matically stored in memory will be displayed for 4 seconds,
and then "END" will appear for 4 seconds.
Notes:
● Only RDS stations will be stored in memory in numerical order.
● If the same station is broadcasting on different frequencies, the
transmission with the strongest broadcast frequency will be
stored in memory.
● Any station which has the same frequency as one which has
been already stored in memory will not be stored again.
● The ASPM operation can be repeated until "END" appears.
● If a 40th station is stored in memory during a scan, the scan-
ning will stop at that station. The number of stations and "END"
will each be displayed for 4 seconds.
● If no stations have been stored in memory, "END" will flash
for about 4 seconds.
● If 40 stations have already been stored in memory and the
ASPM button is pressed, "END" will appear immediately and
the scan will be aborted.
If you want to redo the ASPM operation from the beginning,
erase the preset memory, and then perform steps 1 - 4.
● If the RDS station broadcast signals are very weak, station
names may not be stored in memory.
1
2,3
4
To stop the ASPM operation before it is complete:
Press the ASPM button whilst it is scanning for stations.
● The stations that have already been stored in memory will be
kept there.
To erase all of the contents of preset memory:
The unit is in the stand-by mode.
Hold down the MEMORY button and the TUNING button, and
then press the ON/STAND-BY button.
● "TUNER CL." will appear.
● After performing this operation, all of the preset memory infor-
mation will be erased.
(Main unit operation)
4
(4 seconds)
(4 seconds)
MD-C2H(SUK) TINSE0238AWZZ
19