Filter
Top Products
LSP 500 PRO | 41
The operating menu
Configuring the signal output to additional devices
You can send the signal of the LSP 500 PRO to one or several LSP 500 PRO – either
wired via the LINK OUT XLR output or wirelessly via a transmitter installed in the
SLOT 1 expansion slot. Via the LINK OUT output, you can also send the signal to
an active subwoofer.
To configure the signal output:
X In the SETTINGS menu, turn the MENU jog dial until the DAISY CHAIN menu
item is displayed.
X Press the MENU jog dial to open the DAISY CHAIN menu item.
X Turn the MENU jog dial to choose between MASTER, SLAVE and RIGHT-L.
Option Function
MASTER The overall signal of the LSP 500 PRO is available as a
mono signal at the LINK OUT output and at the SLOT 1
expansion slot.
X Select MASTER if you want to send the overall signal
of the LSP 500 PRO to one or several LSP 500 PRO –
either wired via the LINK OUT XLR output or wirelessly
via a transmitter installed in the SLOT 1 expansion
slot.
X Select MASTER if you want to connect an active sub-
woofer to the LINK OUT output.
SLAVE Only the signal of the LINK IN input is available at the
LINK OUT output and at the SLOT 1 expansion slot.
X Select SLAVE if you want to daisy-chain several
LSP 500 PRO and to adjust the volume only on one
box (master box).
X On the master box, select the MASTER option.
RIGHT-L Right link mode: The signal of the right channel of the
AUX IN, BLUETOOTH and USB stereo inputs is available
at the LINK OUT output and at the transmitter installed
in SLOT 1. The box that is set to RIGHT-L plays the left
stereo channel and the connected box plays the right
stereo channel. The mono signals of the SLOT 1, SLOT 2,
SLOT 3, MIC and LINK IN inputs are played on both boxes.
X Select RIGHT-L if you want to use 2 LSP 500 PRO in a
stereo PA system.
X Press the MENU jog dial to activate your selection.
Settings
Menu
Daisy Chain