Filter
Top Products
12 | LSP 500 PRO
Using the LSP 500 PRO
Charging/replacing the battery packs
To charge the battery packs:
X Insert the battery packs (see page 11).
X Connect the LSP 500 PRO to the mains power supply.
The operation indicator K flashes, the charging process starts. When the bat-
tery packs are fully charged, the operation indicator lights up permanently.
A complete charging cycle takes about 2.5 hours per battery pack when the
product is switched off. If you use the product during charging, the charging
time will be extended.
To remove the battery pack from the battery compartment:
X Open the cover of the battery compartment (see fig.).
X Pull the battery pack out of the battery compartment using the recessed grip
(see fig.).
To check the battery charge status directly on the battery pack:
X Remove the battery pack.
X Press the button to the right of the charge status display.
The battery packs‘ current capacity is displayed for approx. 5 seconds.
LED Color Remaining capacity
1 red, flashing approx. 0-10% (critical)
1 red, permanently lit approx. 10-20%
2 orange approx. 20-40%
3 orange approx. 40-60%
4 green approx. 60-80%
5 green approx. 80-100%
Upon delivery of the product, the capacity is approx. 30 - 50%.
Charge status display
on the battery pack
1 2
3
4 5