Filter
Top Products
LSP 500 PRO | 11
Using the LSP 500 PRO
Mains and battery operation
The LSP 500 PRO can be mains or battery powered. When battery powered,
the LSP 500 PRO uses only one of the two battery packs, allowing a discharged
battery pack to be replaced during operation. The LSP 500 PRO automatically
switches to the second battery pack when the first one is depleted.
When replacing a battery pack during operation, observe the information
on page 13.
CAUTION
Product damage due to unsuitable mains cables or power outlets!
An unsuitable power supply can damage the product.
X Only use the supplied mains cable for connecting the product to the mains
power supply.
X Only use multi-outlet power strips or extension cables with protective ground
contacts.
Connecting the LSP 500 PRO to the mains power supply
X Make sure that the POWER on/off switch L is set to position “ ”.
X Connect the mains cable to the mains socket M of the LSP 500 PRO.
X Connect the mains plug of the mains cable to a power outlet.
Disconnecting the LSP 500 PRO from the mains power supply
X Set the POWER on/off switch L to position “ ”.
X Pull out the mains plug from the power outlet.
Inserting the battery packs
To insert the battery packs:
X Insert the battery pack slightly diagonally into the battery compartment 4.
When inserting, make sure that the charging contacts are located on the top
surface of the battery pack (see fig.).
X Close the battery compartment by sliding the battery pack into the compart-
ment as shown, while at the same time pushing the cover upwards.
X Repeat these two steps for the second battery pack.