Filter
Top Products
88
Creating a Rhythm Set
Tone Pitch Bend Range
(Rhythm Tone Pitch Bend Range)
Specifies the amount of pitch change in semitones (4 octaves) that
will occur when the Pitch Bend Lever is moved. The amount of
change when the lever is tilted is set to the same value for both left
and right sides.
Value:
0–48
Tone Receive Expression
(Rhythm Tone Receive Expression Switch)
For each rhythm tone, specify whether MIDI Expression messages
will be received (ON), or not (OFF).
Value:
OFF, ON
Tone Receive Hold-1
(Rhythm Tone Receive Hold-1 Switch)
For each rhythm tone, specify whether MIDI Hold-1 messages will
be received (ON), or not (OFF).
Value:
OFF, ON
If “NO SUS” is selected for Env Mode parameter (p. 87), this
setting will have no effect.
Tone Receive Pan Mode
(Rhythm Tone Receive Pan Mode)
For each rhythm tone, specify how pan messages will be received.
Value
CONTINUOUS:
Whenever Pan messages are received, the stereo
position of the tone will be changed.
KEY-ON:
The pan of the tone will be changed only when the
next note is played. If a pan message is received
while a note is sounding, the panning will not
change until the next key is pressed.
The channels cannot be set so as not to receive Pan messages.
One Shot Mode
The sound will play back until the end of the waveform (or the end
of the envelope, whichever comes first). The result will be the same
as when the envelope’s Tone Env Mode parameter (p. 87) is set to
NO-SUS. If you have set Wave Group (p. 88) to Sample, the loop
setting will be forced to ONE SHOT.
Value:
OFF, ON
Aftertouch Time Ctrl Sens (Sensitivity)
If Wave Group is set to SAMPLE and Tempo Sync is ON, aftertouch
will control the amount of time stretching/shrinking caused by Time
Stretch. If Time Stretch is not being applied, nothing will happen. If
the stretch/shrink time will become shorter, and if set to “-” the time
will become longer.
Value:
-63–+63
fig.07-009_50
For details on these settings, refer to
“How to make Rhythm
Set settings”
(p. 83).
With rhythm tones, sounds are created by combining up to four
Waves (eight for stereo).
Wave Group
Select the groups containing the Waves comprising the rhythm tone.
Value
INT:
Waveforms stored in internal
EXP:
Waveform stored in a Wave Expansion Board (SRX
series) installed in EXP slots.
SMAP:
Sample waveforms
MSAM:
Multisample waveforms
You cannot select a waveform group of a Wave Expansion
Board that is not installed.
Wave Bank
Select the wave bank.
Value
When the wave group is EXP:
A-D
When the wave group is SAMP:
PRST, USER, CARD
When the wave group is MSAM:
USER, CARD
Modifying Waveforms (Wave)
Tips on Creating a Rhythm Tone
The Waves for the bass drum, snare, hi-hat, toms, and other
percussion instruments are each assigned to one rhythm tone.
When adding 3D effects to the sound, make the Pan settings for
each rhythm tone individually.
Fantom-X678_r_e.book 88 ページ ２００５年５月１２日 木曜日 午後４時４０分