Filter
Top Products
186
Editing Songs
Range Min, Range Max
Specifies the range of note numbers to be transposed. For example, if
you want to transpose notes in the range of C3 through C4, set
“Range Min” to “C3” and “Range Max” to “C4.” You can also
specify the key range by pressing keys on the keyboard.
Bias
Specifies the transpose amount in semitone steps. Set a “+” (positive)
value to raise the pitch, or a “-” (negative) value to lower the pitch. If
you do not want to transpose, set this to “0.”
Value:
-127– +127
This function modifies the keyboard playing dynamics (velocity) of a
specified note area.
fig.19-016_50
For details on the settings, refer to
“Basic Operation for Track
Editing”
(p. 180)
Track / Pattern (Source Track)
Specifies the phrase track(s) or pattern whose velocity will be
changed.
Value
ALL:
Phrase Tracks 1–16
TRK 1–TRK 16:
The specified phrase track
PTN001–PTN100:
The specified pattern
Ch / Part
Specifies the MIDI channel(s) of notes for which velocity will be
modified.
To modify velocity for all notes, set this parameter to “ALL.” When
modifying the velocity for only the notes of a specific MIDI channel,
select that MIDI channel using this parameter.
Value:
ALL, Ch1–Ch16
Measure, For (Edit Range)
Specifies the range of measures whose velocity will be changed. If
you set “For” to “ALL,” all measures will be specified.
Bias
Use this parameter to add a fixed bias amount to all velocities. If you
want to increase the velocity values by 10, set this to “+10.”
Value:
-99– +99
Magnify
Set this parameter if increases or decreases in velocity variations are
desired. For less velocity variation, use settings of “99%” or less. For
more velocity variation, set it to “101%” or greater. With a setting of
“100%,” velocity values do not change.
Value:
0–200%
Range Min, Range Max
Specifies the range of note numbers for which velocity will be
modified. For example, if you want to modify the velocity of notes in
the range of C3 through C4, set “Range Min” to “C3” and “Range
Max” to “C4.” You can also specify the key range by pressing keys
on the keyboard.
This function transfers the MIDI channel of a specified area of
sequencer data into a different MIDI channel.
fig.19-017_50
For details on the settings, refer to
“Basic Operation for Track
Editing”
(p. 180)
Track / Pattern (Source Track)
Specifies the phrase track(s) or pattern in which the MIDI channel
will be changed.
Value
ALL:
Phrase Tracks 1–16
TRK 1–TRK 16:
The specified phrase track
PTN001–PTN100:
The specified pattern
Changing the Velocity (Volume)
(Change Velocity)
If You Want to Lower the Bass Sound One
Octave...
If your bass is played one octave higher than the staff notation,
use the Transpose function to lower it one octave.
To lower the bass sound one octave, set the Range parameter to
“Lowest–Highest” for the bass part, and set the Bias parameter
to “-12.”
When You Want to Change Percussion
Sounds...
You can also use the Transpose function to change percussion
sounds.
Suppose you want to change conga to tom. If the conga sound is
assigned to the D4 key, and the tom sound is assigned to the C3
key, set the Range parameter to “D4–D4” and the Bias
parameter to “-14.”
Changing the MIDI Channel
(Change Channel)
Fantom-X678_r_e.book 186 ページ ２００５年５月１２日 木曜日 午後４時４０分