Filter
Top Products
180
Editing Songs
Track Edit lets you edit areas of sequencer data that you specify.
1.
Access the Song Edit screen, and then load the song you
want to edit (p. 177).
While editing a pattern, press [SONG EDIT] and then press [F2
(PTN)] to access the Pattern Edit screen.
fig.19-007.e
If the Song Edit screen shows “QUICK PLAY,” the song has not
been loaded. If you want to edit this song, press [F8 (Load)] to
load the song.
* Press [F7 (Temp Song)] to return to the temporary song display.
2.
Press [SONG EDIT] and then press [F8 (Track Edit)].
The Track Edit window appears.
fig.19-008_50
3.
Use the cursor buttons to select the desired function.
* You can also select a function by pressing a pad.
Quantize->p. 181
Erase->p. 183
Delete->p. 184
Copy->p. 184
Insert Measure->p. 185
Transpose->p. 185
Change Velocity->p. 186
Change Channel->p. 186
Change Duration->p. 187
Merge->p. 188
Extract->p. 188
Shift Clock->p. 189
Data Thin->p. 190
Exchange->p. 191
Time Fit->p. 191
Truncate->p. 191
For details on the setting windows of each track editing
function, refer to the following explanations of each function.
4.
Set the parameters for each function. Use [CURSOR] to
move the cursor to the desired parameter, and turn the
VALUE dial or press [INC]/[DEC] to set the value. First
check the region that is to be affected by the editing
operation, and then make corrections if you want to change
it.
5.
Press [F8 (Exec)] to execute the operation.
When the operation is completed, the display will briefly
indicate “Completed!”
If you decide not to execute the operation, press [F7 (Cancel)].
• If you are not satisfied with the results of executing the
function, you can press [MENU], and from the Menu window
that appears, select “Undo Track Edit” to return to the state
prior to executing the operation (Undo/Redo).After executing
Undo, you can use Redo to revert to the previous state. After
executing Undo, you can execute Redo by performing the above
procedure the above procedure once again.
Editing Sequencer Data
Over the Specified Range
(Track Edit)
Basic Operation for Track Editing
Current location
Measures
containing
sequencer data
Measure number
Measures
containing no
sequencer data
Indicates the name of the currently
selected song, the measure location,
the time signature, and the sequencer status.
Indicates Loop Play and
Loop Recording
on/off (LOOP).
Indicates the song’s
playback tempo.
Fantom-X678_r_e.book 180 ページ ２００５年５月１２日 木曜日 午後４時４０分