Filter
Top Products
116
Creating a Performance
LFO Osc 2 Pitch Depth
Specifies the depth to which the LFO will modulate the OSC2 pitch.
Value:
-63–+63
LFO Osc 1 Pulse Width Depth
Specifies the depth to which the LFO will modulate the pulse width
of the OSC1 waveform.
* The Pulse Width is activated when “SQR” is selected with OSC1/2
waveform.
Value:
-63–+63
LFO Osc 2 Pulse Width Depth
Specifies the depth to which the LFO will modulate the pulse width
of the OSC2 waveform.
* The Pulse Width is activated when “SQR” is selected with OSC1/2
waveform.
Value:
-63–+63
Range (Solo synth range)
Specifies the range in which the pitch of the solo synth will vary.
Value:
2 OCTAVES, 4 OCTAVES, 8 OCTAVES
D Beam (Assignable)
By assigning a variety of functions to the D Beam controller you can
apply different effects to the sound in real time.
fig.09-015_50
For details on these settings, refer to
“Selecting the Parameter
Controlled by the Realtime Controllers or D Beam
Controller (Control Setting)”
(p. 114).
The settings for the ASSIGNABLE are saved independently for
each performance as part of the performance settings. This lets
you create performances that make effective use of controller
settings.
Type (Assignable Type)
Specifies the function controlled by the D Beam controller.
Value
CC01–31, 33–95:
Controller numbers 1–31, 33–95
For more information about Control Change messages, please
refer to
“MIDI Implementation”
(p. 298).
Bend Up:
Controls the pitch as specified by the “Pitch
Bend Range Up” setting (p. 67).
Bend Down:
Controls the pitch as specified by the “Pitch
Bend Range Down” setting (p. 67).
Start/Stop:
Starts/Stops the sequencer.
TAP Tempo:
Tap tempo (a tempo specified by the interval at
which you move your hand over the D Beam
controller).
Arp Grid:
Arpeggio Grid
Arp Duration:
Adjusts the duration of each arpeggiated note
Arp Motif:
Arpeggio Motif
Arp Oct Up:
The range in which the arpeggio is sounded will
rise in steps of an octave (maximum 3 octaves).
Arp Oct Down:
The range in which the arpeggio is sounded will
lower in steps of an octave (maximum 3
octaves).
Range Min (D Beam Range Lower)
Specify the lower limit of the range of the D Beam controller.
Value:
0–127
Range Max (D Beam Range Upper)
Specify the upper limit of the range of the D Beam controller. By
setting Range Max below Range Min you can invert the range of
change.
Value:
0–127
Fantom-X678_r_e.book 116 ページ ２００５年５月１２日 木曜日 午後４時４０分