Pioneer VSA-AX10 Stereo Amplifier User Manual


 
Using Other Functions
66
En
1
(if necessary)
Functions that can be recorded
STATUS
SPEAKER
A/B
LOUDNESS
INPUT
ATT.
Amplifier
MAIN SUB
SIGNAL
SELECT
TAPE 2
MONITOR
SYSTEM
SETUP
DISPLAY
DIMMER
VIDEO
SELECT
EFFECT/
CH SEL.
BASS/
ATREBLE
TONE
AMP
DVD/LD
VCR1
/DVR
VCR2
VCR3
TV
REMOTE
SETUP
CD-R/
TAPE1
CD
TUNER
VIDEO
SAT
TV
CONTROL
memo
Recording from Audio/Video Components
The following explanations show you how make a recording from one component to another connected to this amplifier.
Note that an analog recorder (such as a VCR) cannot record from a source that is connected using only a digital
connection. Likewise, a digital recorder (such as a CD-R) cannot record digitally from a component that is connected using
only analog connections. In both of these cases, make sure that the digital component also has analog connections to the
amplifier, and that the SIGNAL SELECT is set to ANALOG.
When recording from one digital component to another, bear in mind that the digital signal output from this amplifier
mirrors the input from the source. So if the input is, say, Dolby Digital, the output will also be Dolby Digital. Before
recording, make sure that the recorder is compatible with the source digital audio format.
See p.22 for more on analog audio connections and p.24-25 for digital audio connections.
• The amplifier's volume, channel level, balance, TONE, Digital NR, MIDNIGHT, LOUDNESS,
ACOUSTIC CAL EQ and surround effects have no effect on the recorded signal.
In some cases, digital recordings have copy guard protections and making a digital copy is not pos-
sible. In this case you can only copy them in an analog manner.
When the source is the connected to the MULTI CH IN jacks, only the front left/right channels can be
recorded.
Some video recordings are copy-protected; these sources cannot be recorded.
When recording video, the source must be connected to the amplifier using the same type of video
cord (composite, or S video) as you used to connect the recorder to the amplifier.
1
Select the source component. Set
SIGNAL SELECT according to the
source component's signal (ANALOG
or DIGITAL).
2
Start recording (tape deck, CD
recorder, VCR, etc.)
3
Playback the source to be recorded.
Record monitor (TAPE 2 MONITOR)
If you connect a cassette deck with a record monitor function
to the TAPE 2 MONITOR jacks, you can listen to the sound of
an analog recording as it is being recorded.
Press TAPE 2 MONITOR to switch between the sound of the
recording (TAPE 2 indicator on) and the sound of the source
component (TAPE 2 indicator off).
To record the TAPE 2 MONITOR signal to a recorder
connected to the CD-R/TAPE 1 inputs, select any
input except CD-R/TAPE 1 and switch the TAPE 2
MONITOR on.
memo