Pioneer VSA-AX10 Stereo Amplifier User Manual


 
16
En
Quick Start Guide Part2
11
Check the speaker settings on the
OSD
If they match your speaker configuration make sure
OK,GO NEXT is selected and press ENTER. The
test tones will be output loudly again. The test tones
may take up to 5 minutes this time. After they have
finished, you see the SPEAKER SYSTEMS CHECK
screen. If you want to view the settings select NEXT
and press ENTER repeatedly. If not, simply go to
step 13.
If they do not match the speaker configuration you
hooked up and you want to try again select RETRY
with 5∞ buttons and press ENTER. Follow the
instructions above from step 10.
If the speaker settings do not match the speaker
configuration you connected and you want to input
the settings manually select ERR=FIX SP with the
5∞ buttons, press ENTER and go to step 12.
If you see an ERR message in the right side column,
there may be a problem with the speaker connec-
tion. If selecting RETRY doesn't fix the problem, turn
off the power and check the speaker connections.
12
Use the ∞5 buttons to select a
speaker then the 2 3 buttons to
select the size of each speaker
individually. Use the ∞5 buttons to
select OK, GO NEXT and press
ENTER.
The system will output another series of test tones
to establish the proper channel level, channel delay
and acoustic calibration EQ. Again, be prepared for
loud test tones.
After it has finished, you see the SPEAKER
SYSTEMS CHECK screen. If you want to view the
settings select NEXT and press ENTER repeatedly.
If not, simply go to the next step.
13
Select RETURN to go back to the
SYSTEM SETUP menu, then choose
EXIT to complete the auto surround
sound setup and return to normal
use.
You should now have settings that will give you good
surround sound. The MCACC indicator will light and
the surround sound settings are complete.
memo
Make sure the room environment follows the
guidelines displayed on the OSD during auto
setup. If the room environment is not optimal
for auto setup (too much ambient noise,
obstacles blocking the speakers from the
microphone, etc.) the final settings may be
incorrect. Check for household appliances (air
conditioner, fridge, fan, etc.) that may be
affecting the environment and switch them off
if necessary.
Screens will turn off after three minutes and
the
amplifier will automatically exit from the
setup process.
If you leave CHECK!! or other error message
on the screen for three minutes, or you
choose CANCEL at anytime during the setup,
the settings made up to that point will be
cleared.
After completing the Auto Surround Sound
Setup, ACOUSTIC CAL EQ ON (ALL CH ADJ)
is set automatically.
Check!!
Front [ YES ]
Center [ YES ]
Surround [ YES ]
SurrBack [ YES
X
2]
Subwoofer [ YES ]
[OK,Go Next]
[Retry]
[ERR Fix SP.]
[Return to Menu]
11
Auto Surround Setup
Now Analyzing
•••
Surround Analysis
Speaker Systems [OK]
Channel Delay [OK]
Channel Level [OK]
Acoustic Cal EQ [OK]
[Cancel]
Speaker Systems Check
Normal Surround
Front [SMALL]
Center [SMALL]
Surround [SMALL]
SurrBack [SMALL
X
2]
Subwoofer [ YES ]
[Next] ( Back/Next )
[Return]