Filter
Top Products
Remote Control of Other Components
BASIC
65
En
Setting up the DIRECT FUNCTION
The direct function will not be necessary for most users. It is designed in case you have an external video
source connected to your TV (a video source that is not going through the VSA-AX10). For this explanation we'll
call this the "external video deck." You'd like to control external video deck with this unit's remote control so
you've assigned it a function button (for example purposes, the VCR 2 button). Yet, if you put the amplifier in
VCR 2 mode you'll get no picture on your TV because the external video deck signal is not going through the
VSA-AX10. To get around this problem you set the DIRECT FUNCTION for VCR 2 to OFF. Now when you press
VCR 2 function button you can control the external video deck with the remote but the amplifier does not go into
VCR 2 mode.
1
Press the REMOTE SETUP.
2
Press the DIRECT FUNCTION button.
3
Choose the DIRECT FUNCTION
setting of each MULTI CONTROL
button by pressing on the ON/OFF
button.
A triangular arrow points from the ON/OFF button
towards a small nub next to the function names (DVD/
LD, CD, etc.) that can be turned ON/OFF. This nub will
disappear if that DIRECT FUNCTION is turned OFF.
Subsequently the nub will not appear on any remote
control screen if the DIRECT FUNCTION is OFF.
4
To leave the Direct Function mode
press the BACK button.
The default setting for all DIRECT FUNCTIONs is
ON.
memo
1
2
4
3
AMP
DVD/LD
VCR1
/DVR
VCR2
VCR3
TV
REMOTE
SETUP
CD-R/
TAPE1
CD
TUNER
VIDEO
SAT
TV
CONTROL
Remote Setup
BACK
KEY LABEL
ITEM MEMO
LCD
COMMANDER
MULTI OPERATION
DIRECT FUNCTION
PRESET RECALL
LEARNING
DVD/LD
VCR1
/DVR
VCR2
VCR3
TV
REMOTE
SETUP
CD-R/
TAPE1
CD
TUNER
VIDEO
SAT
TV
CONTROL
AMP
Direct Function
BACK
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
3