Pioneer VSA-AX10 Stereo Amplifier User Manual


 
Techno Tidbits & Problem-solving
EXPERT
103
En
Specifications
Amplifier Section
Continuous Power Output (Stereo Mode)
Front ......... 170 W + 170 W (DIN 1 kHz, THD 1 %, 6 )
Continuous Power Output (Surround Mode)
Front ......... 170 W + 170 W (DIN 1 kHz, THD 1 %, 6 )
Center ..................... 170 W (DIN 1 kHz, THD 1 %, 6 )
Surround .....170 W + 170 W
(DIN 1 kHz, THD 1 %, 6 )
Surr. back ....170 W + 170 W
(DIN 1 kHz, THD 1 %, 6 )
Rated Power Output ...................................
150 W + 150 W
(20 Hz-20 kHz, THD 0.09 %,
6
)
Above specifications are applicable when the power
supply is 230V.
Audio Section
Input (Sensitivity/Impedance)
PHONO MM.........................................4.7 mV/47 k
LINE.....................................................382 mV/47 k
Phono Overload level (T.H.D.0.1 %, 1kHz)
PHONO MM ..................................................... 120 mV
Frequency Response
PHONO MM .................... 20 Hz to 20,000 Hz ± 0.3 dB
LINE .......................................5 Hz to 100,000 Hz dB
Output (Level/Impedance)
LINE ...................................................... 382 mV/2.2 k
Tone Control
BASS .....................................................± 6 dB (100 Hz)
TREBLE .................................................± 6 dB (10 kHz)
LOUDNESS ........................... +4/+2 dB (100Hz/10 kHz)
(at volume position -40dB)
Signal-to-Noise Ratio (IHF, short circuited, A network)
PHONO MM ........................................................ 86 dB
LINE ................................................................... 105 dB
Signal-to-Noise Ratio
[DIN (continuous rated power output/50 mW)]
PHONO MM ................................................... 70/68 dB
LINE ................................................................ 93/73 dB
Video Section
Input (Sensitivity) ..........................................1 Vp-p/75
Output (Level/Impedance) ............................1 Vp-p/75
Signal-to-Noise Ratio .............................................. 70 dB
Frequency Response ..................... 5 Hz to 10 MHz dB
Component Video Section
Input (Sensitivity) ..........................................1 Vp-p/75
Output (Level/Impedance) ............................1 Vp-p/75
Signal-to-Noise Ratio .............................................. 70 dB
Frequency Response ..................... 5 Hz to 40 MHz dB
Miscellaneous
Power Requirements .................AC 220 - 230 V, 50/60 Hz
Power Consumption ............................................... 710 W
Power Consumption in Standby mode .................. 0.65 W
AC Outlet
SWITCHED......................................100 W (0.4 A) MAX
Dimensions .................... 440 (W) × 203 (H) × 472 (D) mm
Weight (without package) ......................................29.3 kg
Furnished Parts
AA IEC LR6 batteries .................................................. 4
Remote Control Unit ........................................................1
Touch Pen ........................................................................1
Cushion for Remote .........................................................4
Microphone ......................................................................1
AC power cord .................................................................1
U-shaped connectors .......................................................2
Operating Instructions .................................................... 1
NOTE:
Specifications and the design are subject to possible
modifications without notice, due to improvements.
Maintenance of External Surfaces
Use a polishing cloth or dry cloth to wipe off dust
and dirt.
When the surfaces are dirty, wipe with a soft
cloth dipped in some neutral cleanser diluted five
or six times with water, and wrung out well, and
then wipe again with a dry cloth. Do not use
furniture wax or cleaners.
Never use thinners, benzine, insecticide sprays
or other chemicals on or near this unit, since
these will corrode the surfaces.
+0
3
+0
3
+0
3