Filter
Top Products
66
En
13 Additional Information
Resetting the system
Resetting the system returns all menu, picture and password
settings to their factory defaults.
Switch the system into standby using the front panel
STANDBY/ON switch. Next, hold down the front panel 7
button and switch back on. All settings will have been cleared.
Noisy radio reception
• Antennas are not connected properly.
Check the connections. For FM, make sure that the
antenna is fully extended and positioned to give the
best reception (See the separate Setting Up guide).
For AM, make sure that the loop antenna is pointing in
the best direction (See the separate Setting Up guide).
• The frequency is incorrect.
Check the radio frequency.
• The radio signal is weak.
If the radio signal is weak, an outdoor antenna will
usually give better results than the supplied indoor
types.
• Other electrical equipment is causing interference.
Other electrical equipment, such as TVs, fluorescent
lamps and motors can cause interference. Try
switching off or moving the equipment, or moving the
antenna(s).
Auto tuning does not pick up some stations.
• The radio signal is weak.
Auto tuning will only detect radio stations with a good
signal. For more sensitive tuning, connect an outdoor
antenna.
Note: Static electricity or other external influences may
cause malfunctioning of this unit. In this case, unplug the
power cord and then plug back in. This will usually reset the
unit for proper operation. If this does not correct the problem,
please consult your nearest Pioneer service center.
Tuner
Screen sizes and disc
formats
The table below shows the effect of various TV Screen settings
on the different kinds of disc available.
When viewing a wide screen TV or monitor
Setting and Appearance Screen format of disc
Standard (TV programs,
etc.)
Your TV will determine how the
picture is presented—check the
manual that came with the TV for
details. Typical options are black
bars either side, some form of
stretched or zoomed presentation.
Widescreen (movies, etc.)
Note that some extra-wide formats
(such as CinemaScope) will appear
with black bars at the top and
bottom of the screen.
16:9 (Wide)
When viewing a standard size TV or monitor
Setting and Appearance Screen format of disc
Standard (TV programs,
etc.)
The program is presented correctly,
regardless of the setting.
Widescreen (movies, etc.)
The sides of the program are
cropped so that the picture fills the
whole screen.
Widescreen (movies, etc.)
The program is shown in
widescreen with black bars at the
top and bottom of the screen.
Widescreen (movies, etc.)
The program appears squashed: set
to either 4:3 (Letter Box) or 4:3
(Pan & Scan).
16:9 (Wide)
Any setting
4:3 (Letter Box)
4:3 (Pan & Scan)
16:9 (Wide)