Filter
Top Products
11
En
3 Getting Started
1 Press SYS, then SETUP.
This puts the remote into surround setup
mode.
2 Press the @ or # button until
you see FRONT in the display.
3 Use the % and fi buttons to set
the distance from your main
listening position to the front
speakers.
Ideally, your listening position should be
equidistant from the two front speakers.
The default setting is 3m. You can adjust
the range from 0.3m to 9.0m in steps of
0.3m.
4 Press # to move on to the
CENTER speaker setting.
5 Use the % and fi buttons to set
the distance from your main
listening position to the center
speaker.
The default setting is 3m. You can adjust
the range from 0.3m to 9.0m in steps of
0.3m.
6 Press # to move on to the
SURROUND speakers setting.
7 Use the % and fi buttons to set
the distance from your main
listening position to the
surround speakers.
Ideally, your listening position should be
equidistant from the surround speakers.
The default setting is 3m. You can adjust
the range from 0.3m to 9.0m in steps of
0.3m.
8 Press ENTER to make the last
setting and exit.
• The setting mode is automatically
exited if no operation is performed
within 20 seconds.
• There are several other settings that
you can make from the System Setup
menu to further tailor your surround
sound. See chapter 10 for more on this.
• The speaker distance settings have no
effect when the Dolby/DTS mode is set
to VIRTUAL SURR1 or
VIRTUAL SURR2. See page 21 for
more on Dolby/DTS modes.
Setting up for surround sound
You can use this system right out of the box for surround sound with just the default settings.
However, for really great surround sound, we recommend that you spend a few minutes making
some settings that match this system to your listening room. These include setting the distances
from your listening position to your speakers, and balancing the speaker volumes. Unless you
change the layout of your speakers or main listening position, you only need to make these
settings once.
Setting the speaker distances