Filter
Top Products
10
En
3 Getting Started
Introduction
This chapter covers switching on and setting the clock, using the Setup Navigator to set
some basic preferences, using all the basic controls for playing discs, and using the
tuner.
Switching on and setting the clock
This system has a built in clock, which needs to be set to be able to use the timer
features.
1 Press SYSTEM to switch on.
2 Press SYS then TIMER/CLOCK ADJ.
3 Press the @ or # button until you see CLOCK ADJUST in the
display.
4 Press ENTER.
If you've just connected the power, the display shows 12:00 AM, with the hour
blinking.
5 Use the % and fi buttons to set the hour, then press ENTER.
6 Use the % and fi buttons to set the minute, then press ENTER.
The display blinks for 2 seconds to indicate that the time has been set.
Tip
Press SYS then DISP anytime to see the clock when the system is on or in standby.
Switching the time format
You can display the clock in either 12 or 24-hour format.
1 Switch the system into standby.
2 Press SYS then TIMER/CLOCK ADJ.
3 Press the @ or # button until you see CLOCK 12 HOUR or
CLOCK 24 HOUR in the display.
4 Use the % and fi buttons to select 12 or 24.
5 Press ENTER.