Filter
Top Products
46
En
11 Controlling Other Equipment
Controlling a component while playing
another
This feature allows you to keep the system in one function (for example, CD) while
putting the remote control in a different one (Video 1, for example). This may be useful
if you were listening to a CD and wanted to rewind a video tape, for example.
1 Press SHIFT, then press the MULTI CONTROL button for the
component you want to
control.
The system remains in the same function, but the remote is in a different one.
2 To switch back to the original function, press the MULTI
CONTROL for the current system function.
It’s also possible to set up the remote so that a particular multi control button always
only switches the remote control mode and not the system function.
1 Press and hold REMOTE SETUP for three seconds.
The LED at the top of the remote blinks twice.
2 Press the MULTI CONTROL button you want to set up.
3 Use the number buttons to enter 983.
The LED on the top of the remote blinks twice. Now, when you press that MULTI
CONTROL
button, only the remote mode changes.
• To change the button back, repeat the above, entering 982 in step 3.
Deleting a single command
1 Press and hold REMOTE SETUP for three seconds.
2 Press the MULTI CONTROL button related to the command you
want to delete.
For example, press VIDEO V-1 if the command you want to delete is one for a VCR
connected to the Video 1 inputs.
3 Use the number buttons to enter 976.
4 Press the same MULTI CONTROL button again.
In the above example, press VIDEO V-1 again.
5 Press twice the command button you want to delete.
Deleting all commands for a component
1 Press and hold REMOTE SETUP for three seconds.
2 Press the MULTI CONTROL button related to the commands you
want to delete.
For example, press VIDEO V-1 if the commands you want to delete are for a VCR
connected to the Video 1 inputs.
3 Use the number buttons to enter 976.
4 Press the same MULTI CONTROL button twice more.
In the above example, press VIDEO V-1 twice.