Filter
Top Products
13
En
3 Getting Started
1 Press SYSTEM to switch on.
Also turn on your TV and make sure that it
is set to the correct video input.
• If a disc already loaded starts playing,
press 7 to stop it.
2 Press DVD then SETUP.
The Setup Navigator on-screen
display (OSD) appears:
Setup Navigator
Audio GeneralLanguageVideo
Move
Exit
SETUP
Select
ENTER
Setup Navigator
Auto Start Off
Start
Navigate all of the following OSDs using
these controls:
%, fi – cursor up/down
ENTER – select the highlighted menu
option
@ – go back to the previous question
The control possibilities for the current
OSD are shown at the bottom of each
screen.
Using the setup navigator
Before playing any discs, we strongly recommend using the Setup Navigator. This makes all the
basic system settings for you.
3 Select START.
Remember: Press ENTER to select an
option.
• If you decide you don’t want to use the
Setup Navigator, select Auto Start
Off here instead.
4 Choose an OSD menu
language.
Setup Navigator
Audio GeneralLanguageVideo
Move
Exit
SETUP
Select
ENTER
OSD Language
Español
français
English
Language
5 Select the type of TV you have.
Setup Navigator
Audio GeneralLanguageVideo
Move
Exit
SETUP
Select
ENTER
TV Type
Standard (4:3)
Widescreen (16:9)
TV Connection
• See Aspect ratio in the glossary on page
58 if you’re unsure of the difference
between widescreen and standard TVs.
6 Confirm all the settings.
Setup Navigator
Audio GeneralLanguageVideo
Move
Exit
SETUP
Select
ENTER
Exit Setup Navigator
Start Again
Delete Changes
Save Changes
7 Press SETUP to exit.
Congratulations, you’ve set up your
system!
If you want to use the Setup Navigator
again at any time, it is available from the
General menu. Also, each individual
setting can be changed using the
appropriate menu option—chapter 9
explains all menu options in detail.