Filter
Top Products
44
En
11 Controlling Other Equipment
Reassigning a MULTI CONTROL button
You can only assign preset codes for certain kinds of components to each MULTI
CONTROL
button. However, if necessary, you can reassign a MULTI CONTROL
button to a different kind of component. You would need to do this if you connected an
MD recorder to the Video 1 inputs/outputs, for example.
1 Press and hold REMOTE SETUP for three seconds.
The LED at the top of the remote will blink twice.
2 Press the MULTI CONTROL button which you want to change.
You can reassign these buttons:
• V-1
• V-2
• A-1
• A-2
• TV
In the above example, press V-1.
3 Use the number buttons to enter 992.
4 Press the MULTI CONTROL button which you want duplicated.
In the above example, press A-1.
5 Point the remote at the component to control and enter the
4-digit code.
If there’s more than one code, enter the first one.
The LED blinks after each button press, and twice to confirm a valid code has been
input. If it doesn’t blink twice, you have entered an invalid code: check the code and
input it again.
If all went well, the remote should have just switched off the other component. If it
didn’t, and the manufacturer has more than one code in the list, start again from step 1
using another code.