Pioneer HTZ-55DV Stereo System User Manual


 
19
En
3 Getting Started
Switching between digital and analog sources
Both digital and analog inputs are available when Audio 1 or Video 2 is selected as the
source. The Input Select setting tells the system which input it should use.
See page 54 for more on connecting other components to this system.
Note: This system can only play Dolby Digital, PCM (32, 44.1, and 48kHz) and DTS
digital audio formats. For digital sources using other formats, use analog connections
and select INPUT ANALOG.
1 Press AUDIO A-1 or VIDEO V-2 (for the input you want to set).
The settings for the Audio 1 and Video 2 inputs are completely independent.
2 Press SYS then SETUP.
3 Press the @ or # button until you see INPUT in the display.
4 Use the % and buttons to select the input to use.
INPUT OPTICAL – the optical digital input is used as the source
INPUT COAXIAL – the coaxial digital input is used as the source (this setting is
only available for VIDEO 2)
INPUT ANALOG – (default setting) the analog inputs are used as the source
5 Press ENTER to make the setting.
Listening to other components
This system has several audio/video inputs for you to connect other components, such
as a VCR, MD deck, and so on. See chapter 12 for more on connecting up other
components.
1 Switch to the source you want to watch/listen to.
There are four external inputs you can connect components to. Select them using the
multi-control buttons:
V-1 (Video 1)
V-2 (Video 2)
A-1 (Audio 1)
A-2 (Audio 2)
Alternatively, you can use the FUNCTION button on the front panel, or press SYS then
FUNCTION on the remote.
2 Start playing the source component.