Filter
Top Products
6 ENGLISH
1. Important information
• Please install and connect the product in the order described in this manual only.
This assures best installation results with the least technical hassles.
• Please read this guide carefully before using your DFR9000 and keep it for future
reference.
• During set-up and installation, it may be helpful to have the instructions for your audio
system,TV or other components at hand.
Safety Precautions
• NEVER MAKE OR CHANGE CONNECTIONS WITH THE POWER OF YOUR AUDIO
SYSTEM SWITCHED ON OR YOUR DFR9000 CONNECTED TO THE MAINS.
• Before operating the set, check that the operating voltage indicated on the type plate on
the bottom of your set is identical with the voltage of your local mains supply. If not, please
consult your dealer.
• The set should not be exposed to dripping or splashing.
No object filled with liquids, such as vases, should be placed on the product.
• Do not expose the set to excessive moisture, rain, sand or heat sources caused by heating
equipment or direct sunlight.
• Allow a sufficient amount of free space all around your DFR9000 for adequate ventilation.
• Do not open the set. Contact your Philips retailer if you experience technical difficulties.
• Place the set on a flat, hard and stable surface.When the set is switched to standby mode,
it is still consuming some power.To disconnect the set from the power supply completely,
remove the AC power plug from the wall socket.
• Do not place the unit directly on a carpeted surface.
• To prevent your DFR9000 from overheating internally, make sure the air around your
DFR9000 can circulate . Also, avoid putting any heat sources (e.g. a DVD player)
underneath.
• To prevent your DFR9000 from overheating internally, never place anything on top of it.
• Do not use extension leads.To avoid safety hazards, use only the mains lead supplied with
your set.
• Do not run mains leads under rugs or carpets or place heavy objects on them.
• Damaged mains leads should be replaced immediately by a mains lead meeting factory
specifications.
• When disconnecting the mains lead from the wall socket, always pull on the plug; never pull
on the lead.
• If you do not intend to use the set for any considerable length of time, disconnect the plug
from the wall socket.
• Before moving the set, be certain to disconnect any interconnection leads with other
components, and make certain that you disconnect the set from the wall socket.
Note:To avoid overheating of the set, a safety circuit has been built in.The set will turn down the
volume or switch off sound completely if it becomes too hot. If this happens, wait until the set
has cooled down.
This set complies with the radio interference requirements
of the European Community.