Filter
Top Products
ENGLISH 29
8. Operating the tuner
Note:We will now describe operating the tuner via the buttons on the remote control. If buttons on
the local keyboard are required for operation, these buttons will be mentioned.
8.1 Tuning to radio stations (FM, FM-M and MW band)
1
Press SELECT (3) to select the RECVR.
2 Use TUNER (4) to select the tuner as source and select the required waveband
(FM, FM-M(ono) or MW). Select FM-M(ono) when FM reception is insufficient.
> The selected waveband is shown on the left display.
3 Keep ∞ or § (8) pressed for about 1 second then release.
> 'SEARCH' appears on TV screen and middle display.The tuner now starts searching for a
radio station with sufficient signal strength.
>Waveband and station (station name or frequency) are shown on the TV screen and the
middle display. If the radio signal is stereo, i will appear.
• Press ∞ or § (8) again to interrupt searching.
4 Repeat step 3 until you find the desired radio station.
• To tune to a weak radio station, briefly press ∞ or § (8) as often as necessary for
optimum reception.
8.2 Preset radio stations (FM, FM-M and MW band)
Up to 40 preset radio stations can be stored in the tuner memory.
Preparation
1 Make sure your TV is switched on.
2 Press SELECT (3) to select RECVR.
3 Press TUNER (3) to select the tuner as source.
Automatic searching and storing
Your DFR9000 searches for radio stations with sufficient signal strength automatically and stores
them in the memory.
1 Press SYSTEM MENU (5) to open the system menu.
> The main menu appears on your TV screen.
2 Use 4 (6) to select ‘Tuner’ and enter with 2 (6).
> The tuner menu appears on your TV screen.
• Press TUNER (4) if you wish to change the waveband.
3 ‘Autoprogram’ will be selected. Enter with 2 (6).
4 Use 3 or 4 (7) to select the station number from which onwards the found radio
stations will be stored and confirm with OK (7).
> 'ACTIVE' appears on middle display and TV screen.
Automatic search starts and radio stations with sufficient signal strength will be stored in
the memory. Already stored radio stations will be deleted.The current station and any
higher station will be deleted.
5 Press SYSTEM MENU (5) to close the system menu.
> Search will stop as soon as 40 radio stations have been stored.
Note: During automatic searching you can leave the ‘Tuner’ menu to make other settings, ‘Active’ then
starts flashing on the TV screen.
Manual searching and storing
1 Press SYSTEM MENU (5) to open the system menu.
> The main menu appears on your TV screen.
2 Use 4 (6) to select ‘Tuner’ and enter with 2 (6).
> The tuner menu appears on your TV screen.
3 Use 4 (6) to select ‘Set presets’ and enter with 2 (6).
> 'PRESETS' appears on TV screen and middle display.
4 Use 4 and 3 (6) to select a preset number.
5 Use 1 and 2 (6) to select a radio station (frequency) you wish to store under the
selected number. Confirm with with OK (7).
> 'STORED' appears on middle display and TV screen.
The radio station is now stored under this number.
1
2
3
4
1
2
3
4