Filter
Top Products
9760-Graphic User Interface Manual
24
3.6 WORK STATION SET UP
The Administrator determines if operators have access to menu commands and function windows (e.g.,
Video window). They can also determine how the Graphic Controller program is initiated; e.g., does the
Manual Selector window automatically load when an operator logs on.
Following are details on how to set up work stations to suit operator requirements. Access to the following
commands and windows is only available when the Administration password is used to log on to the system.
3.6.1 Comm Port Setup
The Comms Port setup window sets the comms between the PC (the Graphic Controller program is running
on) and the CM9760-CC1. This window should normally match the window illustrated in Figure 3-10 (i.e.,
COM1, baud 4800, 8 bits, parity even). The Setup 9760 Program window allows access for programming
the Comms file with the same parameters (refer to The Comms File in the CM9760-MGR manual for more
details).
3.6.1a Administrator Password
Allocating a PIN to the Administrator allows Graphic Controller commands; e.g., camera switching,
to be completed by the Administrator when they log on to the system (in non-design mode). Refer to
Administrator Log On for more information.
Figure 3-10: Comm Port Setup window.
3.6.2 Control Button Setup
Operators can be allocated/restricted access to windows using the Control Button setup.
To allocate/restrict access to a window:
1. Log on to the system using the Administrator password.
2. Select Control Button Setup from the Setup menu option. The Button Selection window (illus-
trated in Figure 3-11) will appear.